Calibration data fitting

[Brendan Kiburg <kiburg@npl.uiuc.edu>]

Hi guys,
  Please take a look at the run10 analysis elog : 
http://kaon.physics.berkeley.edu:8080/analysis-run10/4 . 
  The subject is full kinetics fits to the nitrogren calibration data 
for run10 and run8.
  The conclusion is that the extracted normalized transfer rate depends 
on the impurity concentration, but the value for run8 is completely 
consistent with Francoise's previous value and the value for run10 is a 
bit high.  Assuming that lambda_Ztr stays constant from run to run, this 
implies that the combination of the GC and Claude's volumetric 
calculations are good to only ~10-20 percent.


I will now be focusing on the water calibration for a bit, unless there 
are further requests on this fitting.

Regards,
  Brendan