[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: compressors



Dear Tom,
 I looked around and saw strobe pulses but difficult to judge for ECL signal
without a well adapted probe. Then it remind me that I had the same problem in
Louvain after the lightening. I taught it was the SIS that couldn’t take data
anymore. This evening I went back to the history... and observed that the
controller in the compressor system is presently the same that was present
during the lightening. Could it be guilty even if well functioning on all
other actions?... I exchange withy an other one... and GOSH .... the SIS is
filling and I reach the half full state.

Conclusion
1) One component burnt into the compressor exposed to the lightening
2) May be the SIS3600 in LLN is still alive..

I tried unsuccessfully to reach you by phone...
Can you test again remotely? The compressor is running in test mode in quite a
fast rate and in the continuous mode. So you can test when you wish until we
wake up tomorrow.
Note: .. mozella went out!
Let me know your success if any.

Best regards
René.

Tom Banks a écrit :

> Hi Rene,
>
> I got the DAQ running again shortly after we last spoke, and the problem
> with the SIS3600 giving a "buffer empty" signal is still present.  Could
> it be a problem with the SIS module?  After all, I don't think that we
> ever tested this spare module, and maybe its settings are different from
> the other one which was damaged by lightning in Louvain?  If not, then it
> must be that the signals are not properly connected.
>
> By the way, we looked at the control register settings, and found that the
> old "0x10c00" is the same as the new "0x08010000", if one takes into
> account the default settings; I just wanted to make sure that we hadn't
> fundamentally changed the operating mode from before.  I think it's
> important that we try to replicate the previous operating mode--which we
> know worked--before making any changes.
>
> Tom

--

---------------------------------------------------------------------
 René PRIEELS                       Universite Catholique de Louvain
 email: prieels@fynu.ucl.ac.be      Departement de Physique / FYNU
 Tel  : ++ 32 (0)10 / 47 32 09      Chemin du cyclotron, 2
 Fax  : ++ 32 (0)10 / 45 21 83      B-1348 Louvain-la-Neuve - BELGIUM
---------------------------------------------------------------------