some help from our high energy colleagues

["Paul T. Debevec" <debevec@uiuc.edu>]

Dear Peter,
Our high energy colleagues continue to be very helpful.  Mats sent me to 
Tony Liss.  Mats thinks that he probably borrowed the supplies from 
Tony.  Tony has a test setup for the CDF muon chambers on the third 
floor.  They have 10-15 supplies and are using 8 or so.  Tony handed me 
three more just in case we need them.  Tony and Mike Haney said the 
supply was designed by FNAL engineer Tom Droege.  Tony and Mike have not 
used the remote input.  I sent Tom Droege an email asking him for the 
pin out.  Tony will see if some one else at FNAL might help us out.  Tom 
is actually retired.  I find that the rear connector is identical to the 
connector on the Bertan supply.  I inherited a few of the connectors 
with the Bertan supply, and I find that the connector fits.  Bertan says 
that pin A controls power supply A, pin C controls power supply B, pins 
B and D are ground.  The control is 1 V DC = 1 kV.  The Droege supply 
also uses pins A, B, C and D.  It is likely that the pin out is the 
same, but I certainly could not tell from opening the module.  I may 
find another contact possibility from Tony.  Do you need the connectors?
Regards, Paul


Peter Kammel wrote:

>Dear Paul,
>
>The HV supplies arrived today. All channels are working.
>Thanks again for this prompt and very effective help.
>
>Please have a look at 
>http://kaon.physics.berkeley.edu:8080/run10/223
>
>We need to use the remote input pins on the back side.
>Do you or Mats have any description of the pin-out.
>We we also search for that on the web.
>
>With best regards
>
>Peter
>  
>

-- 
Paul T. Debevec
405 Loomis Laboratory of Physics
University of Illinois at Urbana-Champaign 
1110 W. Green St.
Urbana, IL 61801-3080 MC-704 
Telephone: 217-333-0285
Fax: 217-333-1215
email: debevec@uiuc.edu