| Dear Peter and Paul, I have a copy of the .XLS spreadsheet which is supposed to convert between fields and daq settings. I have an issue though. I'm attempting to put together a series of Turtle and Transport files for the Mucap tune(s) used last fall. When I compare the beam macro I see different magnet names than in the spreadsheet, So much so I wonder I should use the magnets toward the end of the list. The two are consistent up until QSB72 and then the names are different in the macro and spreadsheet. Is this indicating different magnets were used? I also see one of the magnets is the WEN magnet setting, and that's not on the spread sheet either. Is there any information on the other magnets? Is this not as major an inconsistency as I first though? Thanks so much. I'm not entirely sure how to proceed on this point. The sheet says Summer 05, too, so it's recent as of last summer. magnetSet("QSB73", dacQSB73*scale); magnetSet("QSB75", dacQSB75*scale); magnetSet("WEN", dacWEN *scale); magnetSet("QSD02", dacQSD02*scale); magnetSet("QSC01", dacQSC01*scale); magnetSet("AEK01", dacAEK01*scale) ; Is what I find in the macro, versus
in the spreadsheet. Paul, Things are progressing here. The TPC was set back in place Friday morning after as basic a repair as could be hoped for under the circumstances, so that is being readied for run conditions, and the APD's are ready for the resolution measurement. We're waiting on more stable beam, however. Best wishes, see you soon, Peter, Sara |